Hangzhou Fashion Outdoor Co.,LtdE-mail: ricky@fashionoutdoor.com
Home > Military Issue > Content
Disruptive Pattern Material
- May 08, 2018 -

China FashionOutdoor are one of the leading supplier of military items in China and has been in this field for more than 15 years. FashionOutdoor 'advantages are military backpack,army tactical vest etc . Should any of these military items in www.aplce.com  be of interest to you, please contact us freely

Disruptive Pattern Material (DPM) is the commonly used name of a camouflage pattern used by the British Armed Forces as 

well as many other armies worldwide, particularly in former British colonies such as Kenya. It is also the camouflage pattern 

uniform worn by the Indonesian National Armed Forces (TNI).

The main variants of DPM are a four-colour woodland pattern, and desert patterns in two, three or four colours. The Woodland 

Pattern DPM was used with the mediumweight No.8 Temperate Combat Dress (c.1966/1968) and lightweight No.9 Tropical 

Combat Dress (c.1976). The later Desert Pattern DPM (c.late 1980s) was designated the No.5 Desert Combat Dress.[1]

DPM has also been produced in black/white/grey Urban DPM, in various blue tones and even in purples (this last for the Swazi 

Royal Guard).DPM has been phased out in British military service, superseded by Multi-Terrain Pattern.


The British Army first used a form of DPM for the famous Denison smock issued to the Parachute Regiment and British Commandos from the early 1940s. The first examples of this design were said to be hand-painted.[3] The Denison smock design went through minor changes, and continued in use with the Royal Marines and the Parachute Regiment until the 1970s.

1960 Pattern

From 1960, the British Army was issued with the so-called 1960 Pattern field-uniform range to replace earlier plain green uniforms. This consisted of a Smock, CombatTrousers, Combat, a Hood, Combat attached to the smock by the two epaulette buttons, and a third concealed under the collar; and for exceptionally cold conditions, a Parka

The first, limited, use of DPM

A new British DPM was developed in the early 1960s, using the four basic western European temperate colours of black, dark brown, mid-green and a dark sand to make a very effective camouflage that has survived in its basic design, with no more than slight changes to the colours and pattern, until current times.

This design was probably used first on a very small scale for a hooded Smock, Windproof, 1963 Pattern, issued only to special forces.

In 1966 the Army introduced, though not universally, a camouflage field uniform. Known informally as the 1966 Pattern, it was in fact identical in design to the 1960 Pattern kit, though now made in DPM fabric. It is labelled, like the earlier plain olive green version, Smock, Combat, 1960 Pattern and Trousers, Combat, 1960 Pattern.

The 1966 DPM range did not completely replace the plain olive green 1960 Pattern Smock and Trousers, which continued to be worn widely until the 1968 DPM kit was issued. Both the Royal Marines and the Parachute Regiment continued to wear the Trousers, Combat, 1960 Pattern with the Denison smock, and examples of these trousers were made even after 1968. These units eventually stopped issuing the Denison smock (in mid to late 1970s) and adopted smocks in the general-issue DPM while still for a time wearing the plain olive 1960 Pattern Trousers

The 1968 Pattern range—the first general use of DPM

DPM Smock Windproof and trousers, temperate pattern.

Before the 1966 Pattern equipment had reached all units a slightly revised design of Smock, Combat and Trousers, 

Combat were introduced as the 1968 Pattern range. The 1966 Pattern DPM fabric design was changed very little for the 1968 

issue, and it seems that the 1968 Pattern garments were made for some time in the two very similar DPM fabrics. A Hood, 

Combat, DPM, made of DPM cotton fabric and with a plain olive green lining, was also included in the range, fastened as 

required to the back of the Smock with the two epaulette buttons and a third under the collar.

In doing this the British Army was the first to adopt a camouflage uniform universally.

For the Royal Marines, which had a responsibility for NATO's northern flank, a Smock, Windproof, Arctic and Trousers, 

Windproof, Arctic were introduced circa 1972. These were made in a lightweight, but wind-proof, DPM fabric and could be worn 

over quilted jacket and trousers in extreme cold conditions. The design of both smock and trousers differ radically from both the 

standard and para designs. The smock is long and loose-fitting, and incorporates a voluminous wired-rim hood, while the 

trousers have zips in the lower leg to allow them to be put on over boots.

In the mid 1970s a new Smock Parachutist DPM (Para smock) was introduced for the Parachute Regiment and other airborne units. Though made in the 1968 Pattern cotton fabric, its design was closer to that of its predecessor, the Denison smock.

At the same time a Smock, Sniper, was introduced, based heavily on the Smock Parachutist DPM and sharing many of its details. It was distinguished by its padded elbows and shoulders, relocated lower pockets, multiple loops for securing natural camouflage material and hooks for the rifle sling.

During the late 1970s, batches of the 1968 Pattern camouflage were used by the USAF Police Tactical Neutralisation Teams at RAF Upper Heyford as a temporary stand-in for the ERDL/M81 Woodland fatigues

The pattern was changed slightly with subsequent issues. On early 1960 Pattern (manufactured from 1966) and 1968 Pattern 

DPM uniforms the sand coloured base would appear to lighten in tone at night, becoming dangerously conspicuous. This was 

addressed in the late 1970s, when the sand and brown colours were slightly darkened. The 1985 Pattern has fewer, less 

precise dots and the brown is much darker; 1990 and later has a band of new shapes and is smaller; 1994 has an orangey 

colour instead of a tan. Tropical poly-cotton DPM uniforms varied even more; early versions were very brightly coloured notably 

with a russet brown and emerald green which faded to rather unexpected pastel tones of blueish green and pink-brown with 

washing. Late 1970s and early 1980s Tropicals have a more yellowish sand base and are greatly sought-after by those wishing 

to appear stylish, while the final production style in the early 1990s used colours closer to temperate uniforms.

DPM items in the Combat Soldier 95 clothing system have similar colours to the 1966 uniform. However, instead of all four 

colours being printed onto a whitish base, the material is in fact woven in the sand shade and overprinted only with three 

colours. This leads to a loss in contrast between the colours after washing and wear, and the clothing tends to appear darker 

when wet than previous types did

Although slight changes have been made to DPM and the colours, the pattern is easy to recognise. There are also jungle 

versions of DPM where the colours are brighter, and on one variation the tan is darker than the green. A desert variant was first 

issued on a limited basis in the late 1980s. This appeared very similar, but consisted of subdued sand and khaki hues. This was 

replaced by a two-colour version by 1990 because four-colour versions had been adopted by some Middle Eastern countries, 

notably Iraq